Hi, this is Wayne again with a topic “How To Make Packing Tape Ghosts”.
Hello, agnes here with make in this article i’ll, show you how to make this sculpture completely out of tape. To make this project you’ll need the following: a large roll of clear packing tape, a small roll of clear tape, a weighted tape dispenser and a pair of scissors start with a small roll of tape and wrap your fingers using the sticky side up, pay close attention To the fingertips, you’ll want to make sure they have nice round contours instead of sharp blocking angles. This will ensure your hand actually looks like a hand when it’s done when you’re all done. The fingers use a large roll of tape, for the palm of your hand build up at least two layers of tape for this first step.
The second step is to wrap your fingers and palm again, but this time use the tape sticky side down. You’Ll want to build up at least four layers of tape. In total for your sculpture, to release your tape, hand, use scissors to carefully cut a seam cut from the base of your palm up to the base of your fingers. Then slowly wiggle your fingers and gently pull on the tape, with your other hand, until it releases if you’re using your own arm as the model. Like me, i recommend wrapping your hand and arms separately and attaching them later line up the seam. You just cut and close it with tape to make the arm use the same technique, but this time only use a large roll of tape, and it should go a lot faster, be careful when cutting the arm seam. Once you have the two pieces with seams patched, join them at the wrist with tape. That’S it you’re all done! You .